The card choosen was the 4Tronix PiRoCon card (http://4tronix.co.uk/store/index.php?rt=product/product&product_id=182). Selected for four reasons
- Price is reasonable (in my opinion).
- Fits straight onto the Pi through the GPIO - no extra cables needed.
- ScratchGPIO has it as an addon so it makes programming it even easier (see http://cymplecy.wordpress.com/2013/10/31/pirocon-from-4tronix/).
- Others are using it for robot projects.
Use it is quite easy plug the board directly on to the GPIO connector of the Raspberry Pi (4tronix provide some advice in section 15 of http://4tronix.co.uk/blog/?p=22 on mounting the board). The only other changes I needed to make because I wasn't powering the motors through the DC input I had to change the jumper settings next to Vin Connector (see http://4tronix.co.uk/blog/?p=41 for layout) to reflect this.
- Price is reasonable (in my opinion).
- Fits straight onto the Pi through the GPIO - no extra cables needed.
- ScratchGPIO has it as an addon so it makes programming it even easier (see http://cymplecy.wordpress.com/2013/10/31/pirocon-from-4tronix/).
- Others are using it for robot projects.
Use it is quite easy plug the board directly on to the GPIO connector of the Raspberry Pi (4tronix provide some advice in section 15 of http://4tronix.co.uk/blog/?p=22 on mounting the board). The only other changes I needed to make because I wasn't powering the motors through the DC input I had to change the jumper settings next to Vin Connector (see http://4tronix.co.uk/blog/?p=41 for layout) to reflect this.